guzziriders.org - moto guzzi forum Homepage
Forum Home Forum Home > Technical > CARC models
  New Posts New Posts RSS Feed - Norge 122: start-up  error DC V DC ecu 44
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Norge 122: start-up error DC V DC ecu 44

 Post Reply Post Reply
Author
Message
Double-f View Drop Down
Falcone
Falcone


Joined: 13 Nov 2017
Location: Lagos
Status: Offline
Points: 43
Post Options Post Options   Thanks (0) Thanks(0)   Quote Double-f Quote  Post ReplyReply Direct Link To This Post Topic: Norge 122: start-up error DC V DC ecu 44
    Posted: 13 Nov 2017 at 16:22
Hello Guys,

I need your support in solving my Guzzi Norge 1200 refusal to start. This is the background.
During a ride I first experienced the bike going off and refusing to start, checked the fuse box, I saw that the Fuse B (15Amp) is blown, replaced with same rating, bike cranked easily got home unsure why it happened The next time it occurred, it happened in not so good place, but same fuse, but it kept blowning the 15Amp, till u used a 25Amps, it cranked got home, turned off, I then replace with actual rating and everything went just fine.
Fast forward, This morning about embark on trip, turned the key and the red light showed, went into the diagnostic it see it's the ECU 44 (Active) and never responded to startup , but I get the under tank click, and fuel pump is active.  Did some couple of troubleshooting, clean terminals, etc, now I see the error clears (everything looking good to startup Smile) but when I press the start button the error ECU 44 returns Confused. Please I need your experience on how get this baby back on the road. Thanks.
Back to Top
Mike H View Drop Down
Senior Member
Senior Member
Avatar

Joined: 21 May 2014
Location: East Anglia
Status: Offline
Points: 4962
Post Options Post Options   Thanks (0) Thanks(0)   Quote Mike H Quote  Post ReplyReply Direct Link To This Post Posted: 13 Nov 2017 at 18:48
Here are the error codes:

http://www.guzziriders.org/error-codes-for-breva-1100-and-norge_topic7125.html


Error relay starter C.C. Vcc ECU 44


I'm guessing the 15 Amp fuse is for starter solenoid; only going by what's been posted, here and elsewhere, some of the new type starter motors can develop a fault where it draws too much current and blows the fuse. One possible reason may be the solenoid and sliding pinion are "sticky" and need cleaning and lubricating. Only guessing mind you.

HTH (?)




"Chicken nuggets don't dance on a Tuesday."
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.047 seconds.