guzziriders.org - moto guzzi forum Homepage
Forum Home Forum Home > Technical > Big Block Tonti
  New Posts New Posts RSS Feed - LM1 Clutch and Flywheel
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

LM1 Clutch and Flywheel

 Post Reply Post Reply Page  <123
Author
Message
jpc View Drop Down
Senior Member
Senior Member


Joined: 06 Oct 2016
Location: Belgium
Status: Offline
Points: 600
Post Options Post Options   Thanks (0) Thanks(0)   Quote jpc Quote  Post ReplyReply Direct Link To This Post Posted: 24 Dec 2018 at 16:35
You can pre-compress the clutch by temporarily fitting 4 longer bolts around the periphery.

(and use crankshaft thread only for centering and aligning the splines) 

Back to Top
sardineone View Drop Down
Senior Member
Senior Member
Avatar

Joined: 30 Oct 2018
Location: Indiana, USA
Status: Offline
Points: 103
Post Options Post Options   Thanks (0) Thanks(0)   Quote sardineone Quote  Post ReplyReply Direct Link To This Post Posted: 24 Dec 2018 at 16:56
I have a left over inner carrier from when I switched from original to a deep spline clutch and my tool fits inside it.  I had compressed the springs with the plates in place in the past and that's the tricky part not to catch an clutch plate edge or unbalance the pressure ( I inadvertently warped plates that gave me an on-off character clutch).  Using my cheap easy tool insures a as new clutch operation when assembled.
George

One owner 86' Lemans 1000 (member of the family) / BMW R1200ST (current work horse)

You are what you have ridden!
Back to Top
ReggieV View Drop Down
Senior Member
Senior Member
Avatar

Joined: 12 Oct 2014
Location: Leeds,Yorkshire
Status: Offline
Points: 430
Post Options Post Options   Thanks (0) Thanks(0)   Quote ReggieV Quote  Post ReplyReply Direct Link To This Post Posted: 24 Dec 2018 at 17:48
Originally posted by sardineone sardineone wrote:

The pitch on my 86' Lemans is 1.5 and I'd be surprised if yours is different.  I made my own pressure plate compression tool with a M12 1.5 pitch bolt.
 
 
As sardineone said, I can confirm that the pitch is M12 x 1.5 for the flywheel centre hole.
 


Edited by ReggieV - 24 Dec 2018 at 17:59
Back to Top
GuzziPaul View Drop Down
Senior Member
Senior Member
Avatar

Joined: 10 Oct 2015
Location: Essex
Status: Offline
Points: 103
Post Options Post Options   Thanks (0) Thanks(0)   Quote GuzziPaul Quote  Post ReplyReply Direct Link To This Post Posted: 25 Dec 2018 at 17:48
Thanks all.


Back to Top
 Post Reply Post Reply Page  <123
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.00
Copyright ©2001-2018 Web Wiz Ltd.

This page was generated in 0.047 seconds.