guzziriders.org - moto guzzi forum Homepage
Forum Home Forum Home > Technical > Small Blocks
  New Posts New Posts RSS Feed - Identifying throttle body screws
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Identifying throttle body screws

 Post Reply Post Reply
Author
Message
Bugsy View Drop Down
Falcone
Falcone


Joined: 08 Oct 2018
Location: N
Status: Offline
Points: 66
Post Options Post Options   Thanks (0) Thanks(0)   Quote Bugsy Quote  Post ReplyReply Direct Link To This Post Topic: Identifying throttle body screws
    Posted: 19 Jun 2019 at 19:45
Bike is an '07 Breva and I want to identify the various screws associated with the throtttle bodies, in particular the air bypass screws. I assume these are brass and are found on the outside of the bodies, at the base of one of the vertical cast in "tubes" - is that right?

Other screws and settings are yellow paint marked and again I assume should be left alone and I intend to as the bike runs very well!

Just checking the idle speed...

Grateful for any confirmatory info.
Back to Top
Brian UK View Drop Down
Moderator Group
Moderator Group
Avatar

Joined: 13 May 2014
Location: Surrey
Status: Offline
Points: 17641
Post Options Post Options   Thanks (0) Thanks(0)   Quote Brian UK Quote  Post ReplyReply Direct Link To This Post Posted: 20 Jun 2019 at 07:51
There will be an air bypass on each, yes fitted in that tube underneath.
There will also be the balance adjustment screw which alters the length of the linkage between the TBs.
There will be a throttle stop screw which should be sealed with yellow paint and this is factory set, so shouldn't be touched.
Brian.

Better 5 minutes late in this world than years early in the next.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.03
Copyright ©2001-2019 Web Wiz Ltd.

This page was generated in 0.094 seconds.